Upgrade to the next level!

We’ve teamed up with Serato to elevate your Phase experience to the next level: today, Phase becomes an Official Serato Accessory.

Thanks to a powerful HID protocol, Phase is now fully integrated with Serato DJ Pro, offering an even more accurate, reliable, and most importantly, direct connection without intermediate RCA communication.

If you already own Phase, continue with the instructions below. If you’re new, you can grab your Phase here: 

Plug'n'Play:

From now on, Phase can be used without the need for RCA cables. Simply connect the Phase Receiver to your laptop via USB, and that’s it: Phase now communicates directly with Serato DJ Pro via HID.
Enjoy this instant setup: only one step away to set up for your performance.

Improved Performance:

Using a powerful HID protocol, the communication between Phase and Serato DJ Pro is much faster, reducing latency even more. A 100% digital communication that offers you better accuracy and foolproof stability. Digital control has never been so close to using real records!

Custom-designed Features:

When connected to your laptop, Phase is now automatically detected by Serato DJ Pro, offering new dedicated features to enhance your experience with the USB integration.

  • New wireless deck mode: A brand-new Wireless (WIR) Serato DJ Pro mode, uniquely designed to perform with Phase. Select “WIR” in the drop-down menu to control your tracks.
  • Remotes battery level displayed: You can now monitor the level of the battery of your Remotes directly on Serato DJ Pro, just at a simple glance.
  • Emergency internal switch: in case your Remotes are running out of battery (4%),  Serato DJ Pro automatically switches from WIR to INT mode to ensure the continuity of your performance.
  • Custom-designed LED animations: The Remotes now indicate by blinking when a track is loaded, or when a track comes to the end 20 sec before the end of it (with the “Track End warning” box checked in the Serato preferences).

How to Setup

1. Open Phase Manager and update it to the latest version.            

 

2. Update your Phase to the newest firmware available.
Once it’s done, make sure your Remotes are properly
linked to the Receiver

3. Open Serato DJ Pro version 2.5 or higher.
Then, simply connect your Receiver to your laptop via USB.

 

4. Select the “WIR” deck mode in Serato DJ Pro to use Phase via HID. 

 

5. Place your Remotes on top of your records, and as usual, wait a few seconds for the calibration to be done. 

You’re ready to go!

  • Additional Setup Tips:
    You can also run a Manual calibration via Phase Manager to ensure your Remotes are spinning exactly at the right speed. To do so, check out the Phase Manager settings.

Need any help?

If you need assistance with our Phase, check our Help Center to find your solution. If it’s not there, contact our product specialists if you require any further support!